Nice new floor

 needs a good clean 3 years of  dust under the boards

Screws and a dab of Sicaflex should hod these.

Now for the silver tape to finish off the vapour barrier. 

Spray glue and cover with refektis. All done 12mm marine ply next.

Seat adjustment

 Landscape or Portrait

Ok lets cut the single heavy frame.

Tack on some support plates. and 5 x 30x30 box legs 3 in the front 2 in tut back.

After the first test fit this leg had to be moved 60mm to the right to land in the dip like all the other 4.

Close but dim cigar. nearly had a hole in the right place but accident. 

Back OS leg needed to spin 90 degrees clockwise as the hole would be in the cill and no way of getting a nut on it.

drill pilot holes at each leg after making sure the seat is square to the side of the van.

Now fully weld, paint 

I want the ability to remove the seat to service the boiler (Truma 4E) so I have made plates that bolt to the floor and have countersunk bolts to fasten the seat from the top. 

To insulate

 Time to help keep cold out heat in or hopefully keep cool in the med. 40mm Celotex for the ceiling 50mm for the walls and re cycled plastic bottles earth wool.

12mm marine ply 75mm wide screwed and a bit of grab adhesive on each ceiling cross member.

 

The last cross member above the cab.

50mm Kingspan for the sides 

Like a little fridge