Electrickary

 Mock up wheel arch box to hold all the electrics. 

Finished design, 850 long shelf sitting in sides 450 x 650 tall.

240 consumer unit for hook up. Feed in first.

The second connection is 16Amp to the Truma 4e.

Second 16Amp fuse for 2 or 3 sockets.

Now for the 12v side, I fancy having the 12v fuse box set on some nice base up off the shelf so I can tuck in the wire underneath. 

First wire is the thick one for the fridge.

Earth top and live to the bottom these are the feed from the leisure  batt plan is 300AH lithium.

So far Fridge, Truma and kitchen CIG lighter socket on the RH and on the LH roof lights, rear Maxx fan

I have only added 5 appliances and realise I only have room for 12 so may have to have 2 12v fuse boxes side by side. I do like to have each one with its own fuse.

At this rate I have more than 12 things to connect. mmmmmm how much will be my daily use. 

1. Fridge
2. Front fan
3. Rear fan 
4. Truma
5. Truma control panel 
6. Celling lights
7. Bed room reading lights
8. Toilet
9. Toilet fan
10. Toilet light
11. Front seating lights
12. leki step
13. Front USB socket 
14. Rear USB socket. 

Last

Great walls of shower

Lets make a template

Looking good

Transfer to the furniture board

Happy with this side, now on to the rear

Inside template, just add square edge to full 700mm width

Top of the pattern look v good.

Bottom where water hot n cold comes out plus the hot air heating duct. there's a small plastic pipe for the gas to the left of the air duct. 

template for rear wall

Pocket hole stiffeners to hold until I have the front worked out

Some where to rest your arm and place your food.

One thing I have learned, I an no carpenter.

40mm rebate to fit under window frame

Biscuit joint to hold shelf  top down with out screws

Biscuit joint to match shelf  top with a bit of measure 3 times and fingers crossed.

dry fit to check all is good

I had to cut a slot for the seat belt to run smoother

Looking good the Blinds cassette will cover the wood. Now for some tableage.

First pattern 400 wide and too long

450 wide and 600 long

now I only need to find a nice lightweight board 

Feel the heat

 Truma 4e for me

Well over the 500 min from window requirement 

All fits under the double seat.