Friday, September 18, 2020

Seat adjustment

 Landscape or Portrait













Ok lets cut the single heavy frame.










Tack on some support plates. and 5 x 30x30 box legs 3 in the front 2 in tut back.






After the first test fit this leg had to be moved 60mm to the right to land in the dip like all the other 4.
Close but dim cigar. nearly had a hole in the right place but accident. 
Back OS leg needed to spin 90 degrees clockwise as the hole would be in the cill and no way of getting a nut on it.
drill pilot holes at each leg after making sure the seat is square to the side of the van.

Now fully weld, paint 























I want the ability to remove the seat to service the boiler (Truma 4E) so I have made plates that bolt to the floor and have countersunk bolts to fasten the seat from the top. 






at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Give me some shade

 yawninning  unwrap the beast  tree places the brackets need to sit dry fit to start the measure, measure and measure again. the end of the ...

  • Arrival
      2017 Peugeot Boxer L3 H2  The best Van I could find at this time. 70K miles with Sat Nav, Air con, Reverse camera and Cruse control. There...
  • Bumper Replacement
    The Passengers bumper was quite damaged so it has to go Whilst under the bonnet the expansion tank was definitely not transparent. In fact i...